Loading...
← All news
In development

A new motion planner for PlanetCNC TNG

A smooth cut starts before the machine moves. We are building a new motion planner for PlanetCNC TNG to turn demanding toolpaths into smoother, coordinated motion while keeping the programmed shape under control.

Small segments, tight corners and changing feed rates all put demands on a CNC machine. The new planner brings path blending, axis limits and speed changes together, so they can be handled as part of one coordinated plan.

Concept diagram comparing a sharp programmed corner with a smoothly blended path inside a tolerance envelope.
Corner blending follows a smooth transition within the allowed tolerance. Concept illustration; actual paths depend on the program and settings.

What is new?

  • Jerk-limited motion. Smoother changes in acceleration are designed to reduce vibration.
  • True 3D corner blending. Corners are rounded across up to nine coordinated axes, including transitions between lines, arcs and helices.
  • A guaranteed path tolerance. Blending keeps the planned toolpath within the tolerance you set.
  • Better handling of dense CAM code. Thousands of tiny moves are merged so short segments do not unnecessarily slow the machine.
  • Limits checked for every axis. Speed, acceleration and jerk are considered throughout the motion.
  • Smooth pause, resume and feed override. The machine slows and stops on the path, then continues from the same position.
  • The same path at any speed. Changing the feed rate or override does not change the planned shape.
  • Linear and rotary axes planned together. Mixed-axis moves are coordinated in the same planner.
  • Synchronized machining support. Threading and rigid tapping with G33 and G33.1, plus feed per revolution with G95.
  • Backlash compensation and soft limits. Both are built into motion planning.
  • Compatibility with existing Mk3 controllers. No controller firmware update is needed.

What does a motion planner do?

G-code describes where the machine should go. The motion planner works out how to get there: how fast each axis should move, when it should accelerate or slow down, and how one move should connect to the next.

At a sharp corner, the machine needs to change direction. Blending replaces that abrupt transition with a controlled curve. The new planner handles that transition in three dimensions and across all participating axes, while respecting the allowed deviation from the programmed path.

What will users notice?

Smoother movement on demanding toolpaths

CAM programs can describe a curved surface using thousands of short moves. Planning those moves together helps the machine maintain a more consistent flow instead of repeatedly slowing for individual segments. Jerk limiting also makes changes in acceleration less abrupt, helping reduce vibration.

More control over the shape you cut

The tolerance setting defines how far the planned path may depart from the programmed path during blending. That gives you a clear way to control corner rounding. The planner's tolerance describes the commanded path; the finished part also depends on machine accuracy, tooling and cutting conditions.

Feed changes without a different toolpath

When you adjust the feed override, the planned geometry stays the same. You can slow a job down or bring it back up to speed without changing the shape of the blended path. Pause and resume follow that same path, keeping motion predictable when you need to intervene.

A coordinated plan for every axis

Linear and rotary axes are considered together, with speed, acceleration and jerk limits checked for each one. Threading, rigid tapping and feed-per-revolution operations are also supported, alongside integrated backlash compensation and soft limits.

Back to News